31-5029
5 DVD Home Theater in a Box
with Wireless Rear Speakers
Refer to your Owner’s Manual for complete instructions.
Making Connections
GOOD
BEST
BASIC
BETTER
Connecting the
Component Video
Output to Your TV
Connecting the
S-video Output to Your TV
Connecting the Video
Output to Your TV
Connecting to Your TV Using an
RF Modulator (not supplied)
OR
OR
OR
Use a component video cable
(not supplied) to connect the
COMPONENT VIDEO OUT
to a set of component inputs
on your TV.
Use the supplied video
cable to connect the
VIDEO OUT jack to a
video input on your TV.
Use an S-video cable (not
supplied) to connect the
S-VIDEO OUT to an S-
video input on your TV.
Connecting the Speakers
Placing the Speakers
1. Connect the WIRELESS (IN)
jack on the transmitter to the
WIRELESS (OUT) jack on
the rear panel of the receiver,
using the supplied RCA stereo
cord.
2. Connect the supplied AC
adapter to the DC IN inlet on
the rear panel of the unit.
Then plug the other end into
an AC power outlet.
• Place the center speaker directly above or below the TV so that the
sound of the center channel is localized at the TV.
• Try to place all the speakers at an equal distance from the listening
position.
Listening to TV Audio
Through the System
REMOTE CONTROL
Installing
Batteries
• Make sure you disconnect power from all components.
• The wireless mode is the default setting.
• Connect each speaker using the color-coded speaker cable. Match them to the
colored labels above the speaker terminals.
Connect a stereo
audio cable (not
supplied) from the
audio outputs of your
TV to the TV IN jacks
on this system.
• Do not connect any of the supplied speakers to any other amplifier. This may
result in malfunction or fire.
The remote requires two
AA batteries (not supplied).
ARH7078-A
© 2003 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
04A03
Printed in Malaysia
RadioShack Corporation
Fort Worth, Texas 76102
|